No Good Golphers - Pinball Game

01-15002 -    The picture on the right is the new one compared to the old one on the left.  Please specify if you will be adding this part

To an original Slam ramp or one of my new ones.  The parts are slightly different to allow them to fit together.

Service bulletin released for01-15002 . Ball Hang Up Repair Kit A-22599.  http://mirror2.ipdb.org/files/4338/NGG_A_22599.pdf  for more info (thanks Victor)

No Good Golphers Slam Ramp assembly.      

	New slam ramps all stainless steel construction.  All welds are sharp and clean.  I still recommend adding some padding of some sort to the bottom to protect your playfield.  I also put some thick mylar on my game where the flap hits to protect the playfield.
	You can see the new one on the left and the original on the right.  I put felt pads on the bottom to protect my playfield.  I decided not to use the screw on the back like the original and had it welded instead.  My original has been epoxied several times.
	Once again the repro is on the left and the original is on the right.  The original shows the ugly weld on top of the post.  We welded ours too but then ground it flat to look perfect.  You can see some residue of the polishing cream on the flap.  These are stunning units of the highest quality and we made sure that the angle of the screw that holds the mech in place is at the right angle.   Buy with confidence !